solucalc
Zero Discharge, compact,
installed in 1h30
How do I install SoluCalc?
- The SoluCalc is ideally installed as close as possible to the official meter of the water authority
- A pressure regulator that stabilizes pressure before CO₂ injection
- The SoluCalc which allows CO₂ to be injected according to water flow.
- The SoluCalc must be plugged into a 220-volt outlet
- The pressure reducer and CO₂ bottle are connected to the SoluCalc and allow you to control the CO₂ setting according to the pH of the water.
- The CO₂ bottle, connected to the SoluCalc via the pressure reducer, supplies the required gas and controls its injection according to the pH of the water.
From manufacturer to installer
SoluCalc is positioned as a softener manufacturer working only directly with a network of installers. You'll never find us at wholesalers or selling direct to your customers.
How to become an installer?
- Contact our sales team
- Our teams will visit you on site or at your home
- You install your first SoluCalc
- An initial start-up is offered
A solution for every customer
From vacation homes to hospitals, there's always a solution: from 1L/h to 100 cubic meters per hour. Discover the solution that fits your profile:
- For apartments
- For single-family homes
- For buildings with up to 200 apartments
Installation in +/- 1 hour
The SoluCalc is very easy to install. Count on just over an hour's work for an operational device.
Compact device
The SoluCalc is compact and can be installed anywhere in the home or building. In the cellar or garage and even under a sink. Anything is possible.
.
A SoluCalc for everyone
| Your customers | Apartment or house | Ownings |
|---|---|---|
| Capacity | 1 to 8 apartments | 8+ apartments |
| The right choice | SoluCalc 1 inch | SoluCalc 2 inch |
| Max. flow rate | 5m³ per hour | 20 m³ per hour |
| Apartment or house | Ownings |
.
.